Basic Control Power Supply Basic Control Power Supply Enclosure Our Basic Control Power Supply Enclosure comes standard with SafeGUARD UV Systems.

UV Sterilizers SMART UV Sterilizers SafeGUARD UV Systems Basic Control Power Supply PLC UV Controller/Monitor UV Sterilizers Home   Basic Control Power Supply

Monitoring Controls:

"Main Power Indicator Lamp" (1) identifies that power is reaching the Power Supply Enclosure when the External On/Off Switch (2) is in the "On" position.

"Elapsed Run-Time Hour-Meter" (3) identifies "operating hours" of the UV lamps. When the UV
lamp(s) are replaced, the run-time hour meter will need to be reset by pressing the "hour-meter" reset button (4) located near the meter. To reset the meter, the UV systems external main power switch must be turned "On". When the hour-meter reset button is pressed, the existing meter reading will clear and restart at zero. This meter is only available with "Basic Control UV Systems". UV lamps must be replaced after 9,000 hours of continuous operation, failure to do so may damage the lamp ballasts.

"UV Lamp Status Indicators" (5) when brightly lit, identify that the lamp(s) are operating properly. A "Dim" LED identifies a lamp not operating properly or one that is completely out. An LED that is completely out (not dimly lit) signifies that the lamps ballast is not operating and requires service. Lamp Status LED's are available with only "Basic Control" UV Systems.

"Optional Over-Temperature Shut-Down System" (6) is equipped with a temperature sensor located on the UV vessel. When the water inside the vessel exceeds 120° F the Temperature Sensor triggers the Lamp Shutdown Circuit; turning off the lamps, avoiding heat damage and potential failure.

Optional Power Supply Enclosure: PLC Controller/Monitor