|
|
 |
|
|
HP
Series Reverse Osmosis Systems
HP Series Commercial Reverse Osmosis water purification
systems offer a TDS (Total Dissolved Solids) typical
rejection rate of 96%. Quality and performance best
describe the Water Factory HP series R/Os which feature
an exclusive hydraulic permeate safety pressure relief
valve and durable stainless steel frame with non-corrosive
fasteners.
Benefits:
• Provides self-cleaning turbulent flow, which
extends membrane life and enhances performance.
• Protects pump from low-pressure burnout and provides
fully automatic operation.
• Ensures product quality and operation performance
as specified.
• Prevents over pressurization of storage tank
and distribution.
|
|
|
Feed
Water Chemistry
- Hardness - < 15 grains (HP 125/300/600) < 10 grains
(HP 900) < 1 grain (HP 1200)
- Iron (Fe) - < .1 mg/1
- Free Chlorine - <. 1mg/1
- Turbidity – SDI < 5
- Total Dissolved Solids – up to 3000 mg/1
- Temperature – 40 – 100 degrees F (4-38 degrees C)
- pH – 4-11
- Membrane Type: TFC
- Operating Pressure: 175 psi
- Typical TDS Rejection: > 96% |
|
HP Series R/O System Specifications
|
| Model
# |
Nominal
Output |
Recovery |
Electrical
HP |
Motor HP |
Dimensions
W x L x H |
| HP125 |
125
GPD |
25-30% |
110
VAC, 60Hz, 6.2 Amp |
1/3 |
14
x 12 x 17 |
| HP300 |
300
GPD |
25-30% |
110VAC,
60Hz, 6.2 Amp |
1/3 |
29
x 12 x 17 |
| HP600 |
600
GPD |
25-30% |
110VAC,
60Hz, 6.2 Amp |
1/3 |
29
x 12 x 21 |
| HP900 |
900
GPD |
33% |
110VAC,
60Hz, 7.5 Amp |
1/2 |
29
x 12 x 23 |
| HP1200 |
1200
GPD |
40% |
110VAC,
60Hz, 7.5 Amp |
1/2 |
29
x 12 x 23 |
|
| NOTE:
Pretreatment is usually required prior to the R/O
system in order to meet feed water requirements. The presence
of Flocculants, Alum, Polyelectrolytes (cationic polymers) or
other additives can cause membrane fouling. If these elements
are present, a special chemical feed pre-treatment may be required. |
|
|
